Within the few seconds after the compile and run of code or sketch, the RX and TX light present on the Arduino board will flash. To upload and run, click on the button present on the top panel of the Arduino display, as shown below: Now, upload and run the written code or sketch.The COM1 and COM2 ports will not appear, because these two ports are reserved for the hardware serial ports. Click on the Tools -> Port (select the port). So, we will select the Processor as ATmega2560.Īs we select the board, the processor is automatically selected by default.Ĭlick on ' Tools' and select Processor, as shown below: The ATmega2560 microcontroller is used in the Arduino Mega. Open the code or sketch written in the Arduino software.The steps to get started with Arduino Mega are listed below: The green LED will light, which indicates the successful connection between the computer and the board. The USB cable is crucial for the connection between the board and the computer. We can also use Arduino Web Editor, which allows us to upload sketches and write the code from our web browser (Google Chrome recommended) to any Arduino Board. We need to install the Arduino IDE software to get started with the process. We can program the Arduino Mega using the Arduino IDE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |